In.K506 Topside Control OVERLAY

The In.K506 Topside Overlay is the printed plastic film overlay for the In.K506 Gecko-based topside controller used on Arctic Spas Classic Series tubs. Carries the printed button labels and tactile-button protection — the only part of the topside that touches your fingers and the only part that wears out from regular use.

When to replace just the overlay: If the buttons still respond but the printed labels have faded or worn off, or the overlay shows visible cracks or peeling, replace the overlay before considering the full topside. Overlay replacement is much cheaper and takes about 10 minutes.

Will this fit my spa? Yes, on Arctic Spas Classic Series tubs equipped with the In.K506 topside. If your spa is a Custom Series with a different topside (TSC-80, TSC-14), you need a different overlay. Bring your old overlay to one of our three Ontario showrooms for matching if you're not sure. If the buttons themselves don't respond, you need the full In.K506 Topside Control instead.

How to install: Power down the spa at the breaker. Peel the old overlay off (heat gun on low helps). Clean the topside surface with isopropyl alcohol, position the new overlay carefully, press from one edge across to the other to avoid bubbles.